In the field of industrial production, burners are supporting equipment that many major engineering projects need to use, and the burners need to be finely adjusted before being put into use. The lack of scientific installation and commissioning of the burner can lead to the failure of the burner’s energy-saving and environmental protection advantages, and in severe cases, it may increase the risk of furnace bursting.EBICO has dozens of first-line after-sales service engineers, and has accumulated rich experience in the use of burners.
The use of burners at the start-up level
1.Before commissioning, carefully check whether the fuel meets the requirements of the burner; check whether the detection instrument of the gas supply pipeline is normal and whether the opening and closing of the pipeline valve is normal.
2.Carefully check the installation reliability and tightness of all newly installed pipelines.
3.Ensure that the air supply volume and air supply parameters meet the requirements of safe combustion.
4.Guide the operator to read the operating instructions of the combustion equipment carefully and master the knowledge and methods of safe operation.
5.Check whether the gas valve is open every time before starting the machine.
6.Start the power control button on the control cabinet, start the fan control button, and when the combustion-supporting fan works without abnormal phenomena, restart the combustion control button. At this time, the combustion program controller starts to work, through a certain program for ignition, air supply, flame detection, etc. to finally achieve safe combustion.
7.When the combustion controller receives a signal that is not conducive to combustion (for example: ignition failure, unstable air pressure, circuit problems), the combustion controller immediately turns off the gas and sends out an alarm signal. After the failure is resolved, the operator will reset it manually.
8.During the entire operation process, the operator shall refer to the furnace safety operating procedures and production process requirements for operation.
The use of burners at the shutdown level
1.When the temperature in the furnace reaches the set value, it will automatically shut down. The operator does not need to operate, and the controller will automatically turn on when the temperature in the furnace is lower than the set value.
2.During manual shutdown and shift shutdown, the operator shall operate the shutdown according to the prescribed sequence (a. first turn off the combustion control button, b. then turn off the fan button, c. finally turn off the power button).
3.When the shutdown time is long, the operator closes the gas pipeline valve to avoid gas leakage.
The scientific and reasonable operation of the installation and debugging of the burner can make better use of the performance advantages of the burner equipment, and at the same time can effectively extend the service life of the burner. For more tips on the use, maintenance of the burner, please call +86-510-85187837.
With the development and segmentation of the market, a number of well-known burner brands have gradually formed in the domestic market. Here is a brief inventory....
