As the core component of the thermal industry, burner has a great impact on the quality of products. Operating the oil burner in the right way can reduce the maintenance cost and prolong the service life.
Connect the peripheral circuit. When the boiler temperature, pressure and automatic control are realized, please connect the wires according to the wiring diagram of the control system.
The oil suction pipe shall not be close to the bottom of the oil tank, a distance of 80-120mm shall be maintained. Before filling the oil tank, the burner shall be turned off, and the oil can only be filled into the tank after being filtered, and it can be restarted after filling for 20 minutes. The oil system shall not leak oil or gas. Check whether the fuel tank is sufficient before starting the combustion engine.
The size of the damper shall match the nozzle specification. When the burner is used, due to the inconsistency between the matched boiler and the trial boiler when the burner is delivered from the factory, it is generally necessary to adjust the damper properly, and sometimes it is necessary to replace the nozzle with proper specification and injection angle.
The ambient temperature of the burner shall not exceed 70 ℃, otherwise temperature and heat insulation measures shall be taken. When it is used in colder areas, proper insulation measures shall be taken for oil storage device and oil supply and return pipeline system to prevent oil pipeline from blocking due to freezing. At the same time, the control circuit part of the burner shall not be affected by damp or high temperature. Please turn off the burner when cleaning the chimney.
The motor shall be moisture-proof to avoid use in humid environment.
The burner should be installed in a balanced way, and should be used horizontally or vertically to avoid tilting.
When it is not convenient to operate the burner directly, the control switch and electrical protection device shall be connected externally.
Frequently check whether the connection of the burner and its components is firm, loose or not, and whether the position changes.
When the burner is started, prevent people and objects from being injured by the sudden flame
At the round table dialogue, participants had a heated discussion on the industry development trend in 2019. Zhou Guoping, head of the Asia region of EBICO, introduced several new burners developed by EBICO. ...
