-
A 1. Adjustment test of pulverized coal fineness
2. Adjustment test of power consumption of pulverizing
3. Air leakage rate test of air preheater
4. Dust collector efficiency test
5. Combustion adjustment and boiler efficiency test
6. Flow rate, pressure head, power and efficiency test of all kinds of improved fans (or pumps)
-
A Possible reasons:
a. Too much or too little combustion air.
b. If the burner has been used for a long time, please check the air nozzle for blockage.
c. Please pay attention to whether the supply of fresh air in the furnace room is sufficient.
-
A Possible reasons: (The following reasons refer to what happens when the burner is used in the positive pressure furnace of the boiler)
a. It may be that the internal pressure of the furnace itself is too high.
b. It may also be that the diameter of the smoke exhaust pipe is too small or there are too many turns. At the same time, please check whether the smoke exhaust passage is blocked. If a chimney baffle is installed, please pay attention to whether it has been opened. If the resistance in the furnace is too high, it will make a vibration noise when it catches fire. In addition, if the pressure of gas is too high, it will make a special noise when it catches fire.
-
A (1) The fuel pipe diameter is too small.
(2) Air is mixed into the fuel pipe.
(3) Contamination of oil filter
(4) The distance between the oil tank and the burner is too large or there is external leakage.
-
A 1. The controller must be installed in a ventilated environment.
2. The ventilation openings in the suction grid part and the installation space cannot be blocked ornarrowed.
3. There should be no explosion or firepossibilitieson the installation site.
4. Before installation, the internal space of all fuel delivery pipelines shall be carefully cleaned.
-
A When igniting, the flame oxygen content is too low, which leads to unstable combustion, and the burner will surge when running at low load, which can be solved by increasing the air volume.
-
A 1. The distance between ignition electrodes is too long, adjust the electrode spacing.
2. The equipment is polluted,needs to be
3. The ignition electrode or circuit is grounded, to eliminate other connections and replace the damaged electrode or cable.
4. If the ignition transformer fails, replace it.
-
A 1. The external temperature or pressure control has not reached the loweststarting limit.
2. The internal interlock of the burner fails or the wind pressure switch is abnormally
3. The program controller failed to reset.
4. Fan motor overheating
5. Circuit failure
-
A (1) The unstable gas source causes flame fluctuation. Try adjust the pressure and restart.
(2) When the flame detector fails to run, the flame detection probe is grounded, or when it is too dirty, the normal flame cannot be detected and flameout occurs. Try adjust the probe position, clean the probe surface and restart.
-
A There are three types of flameout protection devices.
1. Thermal-sensitive type: also known as bimetal. The bimetallic strip is used as the sensor of the safety protection device, and the expansion and bending characteristics of the bimetallic strip under the action of temperature are utilized. The device has the advantages of simple structure, low cost. Disadvantages are difficult installation, long starting and shut down time and short service life
2. Thermoelectric type: Thermoelectric flameout safety protection device is composed of thermocouple and solenoid valve, which uses different thermoelectric potentials generated by different alloy materials under the action of temperature. Thermoelectric safety device has simple structure, convenient installation, low cost and wide application.
3. Photoelectric type: Also known as ion induction type, this device makes use of the ionicity and unilateral conductivity of the flame during gas combustion. This kind of safety protection has developed from DC induction to AC induction.
